What does Interoceptive Decoupling and Autonomic Restoration conclude, in numbers, about “The Composite Model, Non-Identifiability and Case Evidence”?
Answer: Joined into a three-state model, "lowering higher-order precision lowers defensive drive and recovers conductance" holds inside the model — but that is arithmetic, since \(\pi\) multiplies the only term that raises \(S\), not a finding about bodies. The model has three known defects, the most important being that it cannot represent the situation of Chapter 1; the variant that admits this yields a testable boundary condition, namely that once a standing alarmed prior exceeds about 0.3, lowering \(\pi\) goes from helping to harming. Structural identifiability gives the chapter's main result: four parameter sets reproduce the same cardiac trace to within floating-point error while implying mean visceral conductances from 0.506 to 0.884 and minima from 0.000 to 0.426, so "HRV rose, hence visceral perfusion was restored" writes an assumption as a measurement; what the cardiac channel identifies is only the timing of the response. Finally, under a generator with no effect at all, an AB case design yields an average "improvement" of +0.294 SD because of entry-time selection and autocorrelation, with a naive test declaring benefit in 28.5 % of cases against 61.6 % under a true 0.5 SD effect: a likelihood ratio of about 2.2.
Scope of the numbers: Marked boxes separate published evidence, runnable Python calculations (16 programs), classical sources and the author's models and hypotheses; apart from cited literature data, all data in the book are synthetic.
Data table
The numbers below are printed verbatim by the chapter's Python program and can be reproduced by running it. standard-library Python onlyprinted values that match the answer: 0.294, 0.5, 2.2, 28.5, 61.6
NO treatment effect in the generator; AR(1) phi = 0.6; entry above +1.2 SD. phase-A mean minus phase-B mean, average over 4000 cases: +0.294 SD cases showing ANY improvement: 69.4% cases 'significant' by the naive t test: 28.5% (nominal 2.5%) The apparent improvement is +0.294 SD on average with no effect present, and the naive test declares a benefit in 28% of cases. Two causes, both structural: entry at a high point guarantees the baseline is above the person's own mean, and autocorrelation means the 14 baseline points are worth only about 3.5 independent observations (and the 28 practice points about 7.0), so the naive standard error is far too small. What the same design finds when there IS an effect of 0.5 SD: 'significant' in 61.6% of cases, against 28.5% with no effect at all. So a 'significant' single case is about 2.2 times more likely when a 0.5 SD effect is present than when nothing is: a likelihood ratio of about 2.2, which on any reading is weak evidence. The design does not separate a real half-SD effect from the structural artefacts above. What a single case CAN establish, and what the Chapter 8 checklist asks for instead: a randomised multiple-baseline or ABAB design with the phase change times decided in advance by someone else, a pre-specified outcome, and a randomisation test that respects the autocorrelation. The program below runs that randomisation test on one series with no effect. observed A-minus-B difference: +0.913; randomisation p = 0.704 over 27 admissible change points. A p value near 1/27 is the floor this test can reach, which is itself a limit on what one case can show.
Key formula
Show the full program
# Chapter 6. The desensitisation case analysis, and why a single case cannot
# carry it. A synthetic AB design: 14 daily baseline ratings, then 28 ratings
# "on practice". There is NO treatment effect anywhere in the generator. What
# there is: (a) an autocorrelated series (AR(1), phi = 0.6), (b) entry at a
# high point, because people start practising when things are bad -- the
# selection that produces regression to the mean, and (c) a slow spontaneous
# drift toward the population mean. The program reports how often the naive
# comparison of phase means "finds" an improvement, and what the correct tests
# do. Synthetic data; fixed seed; standard library only.
import math
import random
from statistics import NormalDist
N_A, N_B, PHI, SD = 14, 28, 0.6, 1.0
# population mean rating; entry when the level exceeds +1.2 SD
MU, ENTRY = 5.0, 1.2
def one_case(rng, drift_per_day=0.0, true_effect=0.0):
# burn in until the series is above the entry threshold, then start the
# baseline
x = rng.gauss(0, SD)
for _ in range(200):
x = PHI * x + rng.gauss(0, SD * math.sqrt(1 - PHI ** 2))
tries = 0
while x < ENTRY * SD and tries < 10000:
x = PHI * x + rng.gauss(0, SD * math.sqrt(1 - PHI ** 2))
tries += 1
a, b = [], []
for i in range(N_A):
a.append(MU + x)
x = PHI * x + rng.gauss(0, SD * math.sqrt(1 - PHI ** 2))
for i in range(N_B):
b.append(MU + x - true_effect + drift_per_day * i)
x = PHI * x + rng.gauss(0, SD * math.sqrt(1 - PHI ** 2))
return a, b
def mean(v):
return math.fsum(v) / len(v)
def naive_t(a, b):
"""Independent-samples t, the comparison a case report usually makes."""
na, nb = len(a), len(b)
ma, mb = mean(a), mean(b)
va = math.fsum((x - ma) ** 2 for x in a) / (na - 1)
vb = math.fsum((x - mb) ** 2 for x in b) / (nb - 1)
sp = ((na - 1) * va + (nb - 1) * vb) / (na + nb - 2)
se = math.sqrt(sp * (1 / na + 1 / nb))
return (ma - mb) / se if se > 0 else 0.0
def eff_n(n, phi):
"""Effective sample size of an AR(1) mean; the naive t ignores this."""
return n * (1 - phi) / (1 + phi)
if __name__ == "__main__":
rng = random.Random(1979)
REPS = 4000
T_CRIT = 2.021 # t, 40 df, two-sided 0.05
hits = drops = 0
diffs = []
for _ in range(REPS):
a, b = one_case(rng)
d = mean(a) - mean(b)
diffs.append(d)
t = naive_t(a, b)
hits += t > T_CRIT
drops += d > 0
print(
"NO treatment effect in the generator; AR(1) phi = {:.1f}; entry"
" above +{:.1f} SD.".format(PHI, ENTRY)
)
print(
" phase-A mean minus phase-B mean, average over {} cases:"
" {:+.3f} SD".format(REPS, mean(diffs))
)
print(
" cases showing ANY improvement: {:.1%}".format(
drops / REPS
)
)
print(
" cases 'significant' by the naive t test: {:.1%} (nominal 2.5%)"
.format(hits / REPS)
)
print(
"\nThe apparent improvement is {:+.3f} SD on average with no effect"
" present,".format(mean(diffs))
)
print(
"and the naive test declares a benefit in {:.0%} of cases. Two"
" causes, both".format(hits / REPS)
)
print(
"structural: entry at a high point guarantees the baseline is"
" above the"
)
print(
"person's own mean, and autocorrelation means the {} baseline"
" points are".format(N_A)
)
print(
"worth only about {:.1f} independent observations (and the {}"
" practice points".format(eff_n(N_A, PHI), N_B)
)
print("about {:.1f}), so the naive standard error is far too small."
.format(eff_n(N_B, PHI)))
print("\nWhat the same design finds when there IS an effect of 0.5 SD:")
rng2 = random.Random(1980)
hits2 = sum(naive_t(*one_case(rng2, true_effect=0.5)) > T_CRIT
for _ in range(REPS))
tpr, fpr = hits2 / REPS, hits / REPS
print(
" 'significant' in {:.1%} of cases, against {:.1%} with no effect"
" at all.".format(tpr, fpr)
)
print(
" So a 'significant' single case is about {:.1f} times more likely"
" when a".format(tpr / fpr)
)
print(
" 0.5 SD effect is present than when nothing is: a likelihood"
" ratio of"
)
print(
" about {:.1f}, which on any reading is weak evidence. The design"
" does not".format(tpr / fpr)
)
print(
" separate a real half-SD effect from the structural artefacts"
" above."
)
print(
"\nWhat a single case CAN establish, and what the Chapter 8 checklist"
" asks"
)
print(
"for instead: a randomised multiple-baseline or ABAB design with the"
" phase"
)
print(
"change times decided in advance by someone else, a pre-specified"
" outcome,"
)
print(
"and a randomisation test that respects the autocorrelation. The"
" program"
)
print("below runs that randomisation test on one series with no effect.")
rng3 = random.Random(1981)
a, b = one_case(rng3)
series = a + b
obs = mean(a) - mean(b)
# randomisation test over admissible change points, 8 .. 34
stats = []
for cp in range(8, len(series) - 7):
stats.append(mean(series[:cp]) - mean(series[cp:]))
p = sum(1 for s in stats if s >= obs) / len(stats)
print(
" observed A-minus-B difference: {:+.3f}; randomisation p = {:.3f}"
.format(obs, p)
)
print(
" over {} admissible change points. A p value near 1/{} is the"
" floor this".format(len(stats), len(stats))
)
print(
" test can reach, which is itself a limit on what one case can"
" show."
)Single source and citation
Fan, Y. (2026). Interoceptive Decoupling, Salience-Network Switching and Autonomic Visceral Restoration (Version 1.0.0), Chapter 6: The Composite Model, Non-Identifiability and Case Evidence. 5D Library. https://doi.org/10.5281/zenodo.24020418
DOI: 10.5281/zenodo.24020418 · Read the monograph · 5DL-B-053 · v1.0.0 · CC-BY-NC-ND-4.0
BibTeX
@book{fan2026053,
author = {Fan, Yafu},
title = {Interoceptive Decoupling, Salience-Network Switching and Autonomic Visceral Restoration},
year = {2026},
publisher = {5D Library},
edition = {1.0.0},
doi = {10.5281/zenodo.24020418},
url = {https://doi.org/10.5281/zenodo.24020418}
}Other chapter answers in this book
- Chapter 1 · Interoception and Precision: The First Link Runs Backwards
- Chapter 2 · Switching Between Networks: Dwell Time and Its Cost
- Chapter 3 · The Non-Judgmental Imagery Stream: Trading Errors, Not Gaining Information
- Chapter 4 · Two Autonomic Outflows: The Vagus Does Not Reach the Pelvis
- Chapter 5 · How Much Can Blood Flow Change: The Fourth Power and Autoregulation
- Chapter 8 · Practice and a Pre-Registered Test