Acceptance Sampling Plans and Operating-Characteristic Curves: How Many Items a Buyer Must Inspect on Arrival: chapter answers
Buyers and resellers commonly believe that inspecting a tenth of every delivery is a fair and safe rule: more for large lots, less for small. This book overturns that belief with exact probabilities. Whether inspection stops bad lots depends on the number of items sampled and the number of defectives allowed, and hardly at all on the sample's share of the lot. The project blueprint attributed this claim to Dodge and Romig's 1929 paper in the Bell System Technical Journal; after checking, the book corrects the blueprint: that paper introduced the lot tolerance, the consumer's risk and the prin…
DOI pending · monograph page goes live after publication · 5DL-B-329 · 中文版
- Chapter 1 · The Illusion of the Tenth: Protection Follows the Count, Not the Share
Chapter 1 shows that drawing a tenth from a lot of fifty still accepts a lot with a tenth defective with probability 0.577, and that the lot tolerance falls from 0.3600 on small lots to 0.0044 on large ones; a fixed sam… - Chapter 2 · The Hypergeometric Operating-Characteristic Curve: Acceptance Probabilities Computed Item by Item
Read the table from both ends toward the middle. With no defectives the acceptance probability is of course 1.0000. At a defect share of 0.010, five defectives in five hundred, it is 0.9194, short of 0.95; to reach 0.95… - Chapter 3 · Two Risks at Once: Searching for the Smallest Sample and Acceptance Number
Chapter 3 searches for the smallest plan under two risks and shows that zero acceptance wrongly rejects normal lots at one in a hundred with probability 0.3638. - Chapter 4 · Average Outgoing Quality and Its Limit: What Remains after Rejected Lots Are Screened
Chapter 4 computes average outgoing quality: one plan for lots of a thousand has a limit of 0.01625, and the plan with the least inspection at the same limit inspects 88.0 items per lot on average. - Chapter 5 · Double Sampling and the Average Sample Number: Look at a Few, Then More If Needed
Chapter 5 shows that double sampling with the same protection inspects only 103.2 items on average, 28.8 fewer than the single plan. - Chapter 6 · The Expected Cost of Inbound Inspection: How Many Items Are Worth Checking
Chapter 6 writes inspection as expected cost: the best plan costs 327.82 per lot, 71.32 less than the tenth rule, and lot size enters through cost, not proportion. - Chapter 7 · Eastern and Western Sources: the Qin Statute That Like Vessels Must Match, and the Protection Constraint of Dodge and Romig
Chapter 7 examines the Qin requirement that like vessels match and the protection constraint of Dodge and Romig; a gauge offset can multiply the defect share 8.4 times. - Chapter 8 · The Buyer's Receiving Sheet and a Plan to Refute the Book
Chapter 8 gives the buyer's receiving sheet, the distilled Inbound Inspection Sampling Plan Calculator and a pre-registered test. Marked boxes separate published evidence, runnable Python calculations (22 programs), cla…
Illustrative model calculation, not a live quote